Hi All
When you test reports in IReport you can choose the refresh option and if your report has any user
required parameters you will be prompted for them every time.
In the new Jaspersoft Studio when I run my report it asks me for the parameters the first time I
preview my report. That works, but if I want to check my report against a different parameter set
I cannot.
I know you can pin the input parameters to the preview but you have to remember to do this.
I have to exit Jaspersoft Studio and reload and when I load the report pin the parameters.
When I just close the report and reload it remembers my old parameters.
How do you get the new Jaspersoft Studio to prompt you for the user required parameters every time
or alternately if you forget to pin where can you find this panel/dialog to activate it?
thanks
Peter
2 Answers:
Posted on November 21, 2013 at 3:24am
Hi ilona thanks for the reply.
Like I said
>you can pin the input parameters to the preview but you have to remember to do this.
>if you forget to pin where can you find this panel/dialog?
If you do not pin, once you have put in the parameters the panel/dialog is hidden
and you cannot change the parameters, unless you know to look here.
Until I accidentally found this when resizing the project view yesterday,
I did not know this.
Hope this save some one a bit of frustration.
