gabrecords

Hi Jasper Community, I created 3 reports with JasperStudio. Then i published it to Jasperserver and defined an input control. With this three reports i created a dashboard and linked it to the same parameter. Problem is when i saved the dashboard, when i run it in jasperserver, the dashboard is loading the data even before i get to enter the input control (somehow the input control has one item selected by default? i didn't know why) So my question is how do i prevent dashboard from loading data before input control is applied Thanks for the reply.

Hi, i have a bit of a problem making an HTML5 pie chart with Jaspersoft Studio with my current data set. The table look like something like this:- You see i have two categories and two measures. But in the Chart Properties > Configuration it only allows one measure. I was hoping if someone has an answer for this problem? Thank you very much...

Hi many thanks KKriplani, that function works in limiting the x Axis label. However, how do i make it show the full label when i hover my mouse pointer over the x axis label? Appreciate your feedback :)

Yes, That's exactly what i have in mind KKriplani :) I've been wracking my brain trying to achieve something similar in jasper studio html 5 chart Hopefully you can offer me guidance. Thank you

Is it possible to achieve this (example http://jsfiddle.net/a6zsn/70/) in jaspersoft Studio HTML 5 chart? Refer to the jsfiddle chart, and hover your mouse pointer Africa is the best place.. and it shows a full description tool tip. Is yes, how do i do it cause i can't find a way to do it in Edit Chart Properties > Show Advanced Options Thanks a lot in advance

Hi, I notice something when running a report created via ad hoc view. One of my report failed to load (stuck on loading loop). So i tried to cancel it. After clicked cancelled, the screen directed me to the repository, which is an undesired effect. Is there a way i can stop jasper from doing this. Thanks

Hi, I have a problem with the jasper filter using the adhoc tool. Let's say i have a list of item in the filter below:- A A2 B B2 C C2 Then using the filter i search for A. The search result will display A & A2. However upon selecting one search result (A for example), the search result snaps back to show the whole list and A will be in the Selected tab. Is there a way i can make the search result "stick" and not snap back to the whole list ? Thanks