dan.corbin Posted February 14, 2023 Share Posted February 14, 2023 The password in the data adaptor setup/configuration is not properly stored. When I attempt to create a new data adaptor, the password is entered and successfully tested. However, when I click on the "Finished" button, I receive an exception error stating the password has not been entered. Any suggestions?Jaspersoft Studio 5.6 Link to comment Share on other sites More sharing options...
Jivan Phadtare Posted February 15, 2023 Share Posted February 15, 2023 Hello,I found below community article where similar error was mentioned.Please refer the below article, it seems that workaround is mentioned on this. You can try it.https://community.jaspersoft.com/jaspersoft-studio/issues/3858 Hope this will find you useful. Link to comment Share on other sites More sharing options...
Jivan Phadtare Posted February 15, 2023 Share Posted February 15, 2023 Hello,I found below community article where similar error was mentioned.Please refer the below article, it seems that workaround is mentioned on this. You can try it.https://community.jaspersoft.com/jaspersoft-studio/issues/3858Hope this will find you useful Link to comment Share on other sites More sharing options...
Michael Bielkiewicz Posted February 16, 2023 Share Posted February 16, 2023 Also, I'd suggest downloading the latest Jaspersoft Studio. Even if your server is an older version (I really hope you aren't still on 5.x!), you can use the compatibility mode on a newer JSS to compile reports to match an older JRS. Good luck! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now