Side by side Subreport

[cris_tyna]

Hello,

I want to create a report with 2 subreports side by side, in line (one next other), not one below other.

I need some help with this.

Thanks in advance.

[redwine]

cris_tyna,

 

hi!

how can we help you today?

 

note on subreports: they stretch as far down as they necessarily must.

if you need to make sure that the elements below the two subreports (that are side-by-side) float together, try using a "pusher line". This is just a floating line (usually transparent) that you place below your subreports to make sure that the relative vertical position of the elements below both your subreports do not change.... the elements will float at the same time even if the actual heights of your subreports differ greatly from each other.

 

for further explanation and to clarify what you really need to know. just post your specific requirements and we (you and everyone here in the forum) will try to figure out how to go about it.

 

edwin

 

Post edited by: redwine, at: 2007/05/30 14:13

Post edited by: redwine, at: 2007/05/30 14:14