manshack_one Posted February 17, 2010 Share Posted February 17, 2010 I have a report that had been running fine. Not sure what I changed but I'm now getting this error when compiling.Band height validation for subreport "HCD-Diabetes Summary" failed in the current page context (height = 792, top margin = 40, bottom margin = 40) : 1. The summary section and the margins do not fit the page height The main report and subreport are both set to 792. I don't know where it's seeing margins at 40 becuase everything I see shows the margins at 20. The summary sections of both reports are set to 750 but that shouldn't matter since the subreport component is going to use an entire page anyhow. Where do I look to get this error resolved? The subreport runs on it's own without problem. The main report will also run if I don't use this subreport. What happened? -Robert Link to comment Share on other sites More sharing options...
manshack_one Posted February 18, 2010 Author Share Posted February 18, 2010 Ok, I don't know why it picked up 40 on the margins so to fix the issue I went into the subreport and set it's top margin to 0. Link to comment Share on other sites More sharing options...
chiranjib.innowave Posted August 29, 2019 Share Posted August 29, 2019 You have to make your sub reports height and width either same or less than the Main report ex:- main report width is 595 and left and right margins are 20 and 20 ...then subreports width=595-(20+20)=555 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now