TIBCO Jaspersoft® ETL Studio delete external library or external module

Problem:

Removing an external library or external module from TIBCO Jaspersoft ETL Studio in case the external library or external module needs to be changed or replaced

Cause:

When placing a component for DB connection in TIBCO Jaspersoft ETL Studio an installation request for an external library or external module(for example, the JDBC driver) occurs only once at the beginning. So once done, we cannot directly replace the external module and first we need to remove or delete that external library or module in order to use a different library or module.

Resolution:

The workaround to fix the problem are given below. Please refer the following steps to replace or change the external library or external module -

1. Stop the TIBCO Jaspersoft ETL Studio.

2. Go to the < TIBCO Jaspersoft ETL Studio _installation>configuration.m2repositoryorgtalendlibraries.

3. Select the external library/module you want to remove (external library folder) -> delete it from this location.

4. Start TIBCO Jaspersoft ETL Studio and open the job

5. Go and check in the Windows -> show view -> Modules -> check if the external module is present in installed state there or uninstalled state.

6. The external module or library will now be returned to the non-installed state.

7. Install it again.