howto make subreports without overlapping?

[lastochka]

Here is master-report example with subreports:

in iReport  Detailed (or title) block I can't increase summary height of all subreports so, that it will fit in 1 page, and I can't increase height of Detailed (or title) blocks more than 1 page.  

But  - my subreports have height about 5-15 ctntimeters, so I get this:

(don't call attention to  null's - it's just such test select queries, subreport headers are same)

You can see displacement on 1-1.5 centimeters for every subreport - depends of which height set in master-report.

How to tell to iReport to print subreports one after another without overlapping?

 

[lastochka]

Haha, to the 1st subreport you need to give

position type=fix relative to top

and all next - float

 

I did not look close, but if put to everybody float, or stretch type = relative to band height - on report generating it going to infinite loop and dies on disk freesize end (due to logs are writing up to 1-2-5-10 Gb) )))

 

[Teodor Danciu]

Hi,

 

Please try to isolate each subreport in its own band, especially since recent versions of JR come with support for mult-band detail section.

 

I hope this helps.

Teodor